Top Module Display Reviews

DORHEA 5PCS TM1637 0.56\ 4 Bits Digital LED Display Module with Clock Display 0.36 inch Common Anode Red Digital Tube Board with Cable for Arduino Raspberry Pi DIY Kits

The module is a 12 foot with a clock point four common anode tube (0.36 in.) display module driver IC is TM1637 driver IC TM1637, only two signal lines can make the MCU control 4 8 digital tube..
Display device is a total of 4 red LED word tube. Digital tube 8 grayscale adjustable. Control interface level can be 5V or 3.3V..
4-digit LED display module with LED brightness adjustable and clock point, can be used to display decimal, letters and so on, suitable for uses in induction cooker, micro-wave oven and small household electrical appliance..
Total 4 pins (GND, VCC, DIO, CLK), GND to ground, VCC for the power supply, DIO for the data input and output pins, CLK for the clock signal pin..
The Positioning holes in this LED Display Module 4 Bits has 4 M2 screws positioning hole diameter is 2.2mm and the positioning of the module is easy to install with easy to achieve the inter-module combination..

Check Stock

Basic 16x2 Character LCD - RGB Backlight 5V

DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
WIDE APPLICATION: This module is suitable for Raspberry Pi 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..

Check Stock

5 Pieces I2C Display Module 0.91 Inch I2C OLED Display Module Blue I2C OLED Screen Driver DC 3.3V~5V(Blue Display Color)

What will you get: there are 5 pieces OLED display module with blue display color, self-illuminated and no need backlight.
Power-saving display: the I2c oled display performs better than the traditional LCD display and with lower consumption sicne the IIC (I2C communications) simplifies connections.
Please note that these I2C OLED display module comes without pin headers.
More details: use compatible with Arduino, ESP8266, ESP32, STM32, etc..
Good compatibility: this i2c oled display module is compatitable with Raspberry Pi 4B/3B+/3B/2B/Zero, compatitable with Arduino, also compatitable for ESP8266, ESP32, STM32, etc..
Product manual: as shown in the instructions.

Check Stock

4-Digit 7-Segment LED Display Clock Module with TM1637 IC Compatible with Raspberry Pi Arduino (Blue LEDs)

[Specifications] This is a basic 4-digit 7-segment Led display clock module, the LEDs are blue..
[Compatibility] This clock module uses TM1637 IC, it compatible with Raspberry Pi and Arduino.
[Easy to Use] The clock module connected to digital I/O via 2 pins..
[Easy to Install] This LED display designed with 4 mounting holes for easy installation..
[High Quality] The clock module is made of high quality electronic components, stable and reliable performance.

Check Stock

JM Set of 3 pcs Transparent 3D Floating Frame Display Holder/Box/Frames for Challenge Coins, AA Medallions, Antique, Jewelry,Gift, White, 2.75 x 2.75 x 0.75 Inches

What will you get: there are 5 pieces OLED display module with classic display color, self-illuminated and no need backlight.
Power-saving display: the I2C oled display performs better than the traditional LCD display and with lower consumption the IIC (I2C communications) simplifies connections.
Please note that these I2C OLED display module comes without pin headers.
More details: use compatible with Arduino, ESP8266, ESP32, STM32, etc..
Good compatibility: this i2c oled display module is compatible with Raspberry Pi 4B/3B+/3B/2B/Zero, compatible with Arduino, also compatible with ESP8266, ESP32, STM32, etc..
Product manual: as shown in the instructions.

Check Stock

Key Display for AVR 8-Bit Digital LED Tube 8-Bit TM1638 Module

DRIVER IC: The module driver IC is for AIP650 (compatible for TM650), as well as supports multiple display characters..
4 DIGIT 7 SEGMENT: The digital tube display module is designed for 4 digit 7 segment, with stable and reliable performance..
CONTROL INTERFACE: With 4 pins, SDA is bidirectional data line, SCL is clock line, GND is for ground line, and VCC is power supply..
COMPACT STRUCTURE: The LED digital tube module is exquisite and compact, which can be flexibly used in a variety of situations..
WIDE APPLICATION: This module is suitable for 3 B+ 4, for DIY electronic devices, toy cars and instrumentation etc..

Check Stock

LED LCD TV VByone LVDS Turn VGA Converter TV Motherboard Tester EXV2080 Good Price

...ng the situation of misjudgment, making the test more perfect and judgment more accurate..
2.When testing TV motherboard, it can test two groups of FHD LVDS signals at the same time, so the test is more comprehensive. At the same time, EXV2080 also has its own image-detail display function, which makes the characters clearer when adjusting the LCD module parameters. The built-in LCD can achieve local definition equivalent to 1600 * 960 in magnification mode. When the external display is connected, the dual screen display function can be achieved, and the local definition in the magnification mode is equivalent to that of 2K display..
3.EXV2080 has its own operation interface, which can be directly seen all parameters of TV motherboard and LCD module. EXV2080 also has its internal protection circuit. When VLCD and GND are short circuited, it can automatically judge and prohibit output..
4.EXV2080 withmicroUSBdataupgradeinterface,support software upgrade. When there isanew demand,you can upgrade thefirmware to maintainits best compatibility..

Check Stock

waveshare for Raspberry Pi Pico Evaluation Kit B Include Pi Pico Board with Pre-Soldered Header,1.14inch RGB Color LCD, 10DOF IMU Sensor Module,Dual GPIO Expander,Breadboard

Raspberry Pi Pico Evaluation Kit inlclude Raspberry Pi Pico with pre-soldered header ,1.14inch LCD Display Module,10-DOF IMU Sensor Module,Dual GPIO Expander ,830 Quality Breadboard etc.
Raspberry Pi Pico Board,a tiny, fast, and versatile microcontroller board,Built Using RP2040 Microcontroller Chip Designed By Raspberry Pi.
1.14" LCD Display Module for Pico ,Embedded ST7789 Driver, Using SPI Bus.
10-DOF IMU Sensor Module,an IMU sensor expansion module specialized for Raspberry Pi Pico. It incorporates sensors including gyroscope, accelerometer, magnetometer, baroceptor, and uses I2C bus for communication..
Dual GPIO Expander for Pico,Two Sets Of Standard Raspberry Pi Pico GPIO Male Headers.

Check Stock

Adamanta 32GB 2x16GB Memory Upgrade Compatible for 2017 Apple iMac 27 Retina 5K Display DDR4 2400MHz PC4-19200 SODIMM 2Rx8 CL17 1.2v Dual Rank RAM DRAM

32GB ( 2x16GB ) DDR4 2400 Mhz Non-Parity/Non-ECC Unbuffered SODIMM Memory 260 pin Dual Rank Module..
Compatible with all 2017 27 inch w/ Retina 5K Display iMacs of every specification! Compatible with 2017 27" iMac with 5K Retina Display with the....
Compatible with all 2017 21.5 inch w/ Retina 4K Display iMacs of every specification! Compatible with 2017 21.5" iMac with 4K Retina Display with the....
Every module is backed by a limited lifetime warranty. We always have hundreds in stock! Free technical support from our experienced technicians..
Every single memory module is fully tested by the manufacturer. Our experienced technicians can verify if these parts will work for you..

Check Stock

5PCS 0.96 Inch OLED Display Module, PEMENOL 28 x 64 Pixel I2C IIC Serial 1 OLED LCD Display Module with SSD1306 Driver for Arduino Raspberry Pi and ESP8266（White Light）

This is a new 2.8 inch serial SPI color display module with touch function.
Designed with one socket for memory card.
With PCB plate (including power supply IC, Memory Card), compatible with 5110 interface.
5V compatible, use with 3.3V or 5V logic.

Check Stock

AITRIP 3pcs Multi-Function Shield ProtoShield Multi-Functional Expansion Board Sensor Shield Module with Four Digital Display Compatible with Arduino

4 LED lights (LED indicator to know the importance of doing in the actual project, with this indicator can work directly with the program status indicators for easy debugging..
AITRIP 3pcs Multi-Function Shield ProtoShield Multi-Functional Expansion Board Sensor Shield Module with Four Digital Display Compatible with Arduino.
Four digital (using 74HC595 driver provincial IO learning SPI), you can do digital display test (can display temperature, voltage, counter value, etc.)..
Expansion board directly connected with LD3320 non-specific voice recognition module, you can achieve voice control..
Expansion board directly with the SG90, MG945 MG995 and other steering gear connected to achieve the robot and other complex actions..
Expansion board directly with the SYN6288 free voice module docking,it can achieve voice broadcast function..

Check Stock

LCD Module 2004A 5v IIC I2C LCD Display Module, Blue Screen White Character Serial Peripheral Interface

The module is a low-power consumption character LCD Module with a built-in controller..
The module can be easily interfaced with a MCU..
Display Format: 20 Characters x 4 lines..
It is fantastic for Arduino based project..
Fully assembled and tested Serial LCD 20x4 Module..

Check Stock

1.8 inch SPI TFT LCD Display Module for ST7735 128x160 51/AVR/STM32/ARM 8/16 bit

This is a new 1.8 inch serial SPI color display module.
Support analog SPI and hardware SPI. SPI serial, less I/O port need.
Designed with one socket for sd card and PCB adapter for LCD.
The LCD display module can be driven by 8051 / AVR / PIC /ARM/STM32.
The 4D systems lcd display can be driven with at least four IO.

Check Stock