Top Three phase Voltage Regulator Reviews

10000W SCR Digital Voltage Regulator,AC 220V 80A Electrical Motor Speed Controller Regulator, High Power Voltage Regulator Dimming Thermostat

  • 10000W resistance load limit power, room temperature for a long time is recommended to be used within 5000W, voltage regulation: AC 10V to 230V (adjust begin 20V), this is an easy-to-use voltage regulator that can control the brightness or speed of the light. Use a new bidirectional high-performance thyristor. The current can reach up to 100 A, and solves the problem of overcurrent caused by small resistance when the induction cooker cable is cooled..
  • 10000W SCR voltage regulator standard aluminum housing safe and durable super power electronic voltage regulator. It is widely used in resistive loads, such as heating wires, incandescent lamps and most (not all) single-phase AC motors..
  • 10000W speed controller operating voltage AC 110V-230V. Maximum power 10000W (resistive load), long term operating power 7000W. Voltage adjustable from AC 0V to near input voltage. Full copper 75A super large current terminal. The trigger circuit is unique, the control voltage is accurate and there is no hysteresis, the resistive load is turned off to 0, and after starting, it will be adjusted from 10V, adjust to the supply voltage that is closest to the input..
  • Connect the SCR voltage regulator to the front of the circuit of the electrical appliance. The ''input' and """"....
Check Stock

Omron K8DS-PH1 Phase Monitoring Relay

  • The base of the protector adopts a rail type with two screw holes, which can be directly installed separately or mounted on the HT35 rail..
  • Use 5 indicators to indicate: normal, phase loss (voltage three-phase unbalance), reverse phase, overvoltage and undervoltage..
  • Phase loss protection means that when the protected line is in the running state or non-operating state, any phase failure occurs, and the delay is 2S..
  • Overvoltage protection means that the voltage of the protected line is higher than the set value, and the delay is 3~8S, and the recovery is 6~20VAC..
  • Reverse phase protection, a protection measure to prevent L1, L2, L3 three-phase AC phase sequence from being connected incorrectly, delay 2S action..
Check Stock

Simran Power Converter Regulator Stabilizer with 110 Volt - 220/240 Volt Built-in Voltage Transformer, 20,000W (AR-20000)

  • 20,000 Watt Regulator with built-in 110v-240v voltage transformer. Note this transformer will not work with 2-Phase 220/240 Volt power.
  • Converts 110/120V to 220/240V or converts Single Phase 220/240V to 110/120V. Compatible with 50hz/60hz.
  • This stabilizer can regulate big range fluctuating voltage into general voltage output.
  • Input voltage AC 75V-130V or 180V-260V. Output voltage: AC 110v+-4% or ac220v+-260v.
  • 5 outlets on front of unit (accept US plugs and 2 prong Euro plugs). on/off switch. Thermal fuse - protects damage to your valuable equipment. Comes with terminal connectors - hardwire input required.
Check Stock

1Pcs Photocell Cap,TwistLock Photocell Shorting Cap,Photo Control Sensor Receptacle with Surge Protection,Dusk to Dawn 3 Prong Bypass Cap

  • ◆ Function: phase sequence detection, live line check, simple performance check, live cable identification, phase loss assessment, search for cable break position, detection of DC line break point, line maintenance.
  • ◆ Non-Contact Inspection: Non-contact inductive measurement of the terminal type without opening the cable, without touching the exposed high voltage fire cable, with the three highly insulated super inductive terminals inserted directly into the cable insulation skin 3-phase live detection for safe and quick productivity..
  • ◆ Positive and Negative Phase: With the LED display, dynamic sound and light perfectly show the positive or negative phase of the phase sequence of the three-phase power supply, which can be seen at a glance..
  • ◆ Magnetic base: The base plate of the instrument is equipped with 4 magnets that can stand a quality of 800 g. They can be attached to the metal case of the device during the test, and it is convenient and convenient to use..
  • ◆ Wide Voltage Test: This phase meter can detect three-phase voltages from 70V to 1000V and has excellent performance..
Check Stock

Siemens 3UG4631-1AA30 Monitoring Relay, Single Phase Voltage Monitoring, Screw Terminal, 1 CO Contacts, 0.1-60VAC/DC Measuring Range, 0.1-30V Hysteresis, 0-20s Delay Time, 24VAC/DC Auxiliary Voltage

  • Features: Undervoltage protector integrates three-phase voltage protector, chronograph and counter in one.
  • Multifunction: The protection relay has protection functions such as overvoltage, undervoltage, phase loss, phase sequence, three-phase voltage unbalance, etc.
  • Practical functions: The voltage monitoring relay has functions such as start-up delay and output test. 2 rest module optional, manual and automatic.
  • Specification: Monitoring Circuit: L1, L2, L3.
  • LCD Display: LCD data display, easy to read, no external power supply required.
Check Stock

PRINCE CASTLE Drive Motor Assembly 87-028AS

  • ATO 110v vfd, single phase 110v/120v input, single phase or three phase 220v output, achieve to run 220v AC motor on single phase 110v/120v power supply.
  • 【Voltage& Frequency】Input voltage: 1 phase 120V AC ±15%, Input frequency: 50Hz/60Hz,Output voltage: 1 phase or 3 phase 220V AC ±15%, Output frequency: 0.00~400.00Hz.
  • 【APPLICATION】ATO 7.5 hp 5.5kW variable frequency drive Can be widely applied to drive the AC motor, such as fans, pumps, power tools, etc.
  • 【TIPS】 To protect the variable frequency drive and Motor, you need an upstream protection, add a line-choke upstream the VFD, this will reduce the current transients seen by the input of the VFD.
  • 【CUSTOMER FIRST】If you have no experience in driving a VFD, be sure to refer to the instructions before operating a VFD.If you are not sure about the size or have any issue about the product or service, please don't hesitate to email us. We will answer you within 12h.
Check Stock

Digital Phase Indicator , Akozon SP8030 Digital Phase Rotation Indicator LED Buzzer Phase Sequence Meter 200 ith Bag

  • It is durable, reliable and light-weight handheld device, which is necessary tool for those who often install, repair or maintain three-phase system or motor..
  • Without a need to link testing line, the motor rotation direction can be decided by placing this indicator above the motor and aligning it with motor drive shaft..
  • Used to test phase sequence input of three-phase voltage, to indicate phase line L1, L2 and L3..
  • PM5900 Motor and Phase Rotation Indicator is used to test magnetic field direction of three-phase system, phase rotation, motor rotation direction..
  • It also supports non-contact type magnetic field rotation direction test (motor rotation direction test)..
Check Stock

Phase Sequence Meter, 60V ~ 600V AC 3 Phase Sequence Rotation Tester, with 5 LED Lights, for General Measuring Tool

  • It is durable, reliable and light-weight handheld device, which is necessary tool for those who often install, repair or maintain three-phase system or motor..
  • Used to test phase sequence input of three-phase voltage, to indicate phase line L1, L2 and L3..
  • PM5900 Motor and Phase Rotation Indicator is used to test magnetic field direction of three-phase system, phase rotation, motor rotation direction..
  • Without a need to link testing line, the motor rotation direction can be decided by placing this indicator above the motor and aligning it with motor drive shaft..
  • It also supports non-contact type magnetic field rotation direction test (motor rotation direction test)..
Check Stock

SZCY LLC AC 220V/2.2KW Variable Frequency Drive, 12A VFD Inverter Frequency Converter for Spindle Motor Speed Control (Single-Phase Input, 3 Phase Output)

  • Application: Spindle Motor, Drill Press, CNC, HVAC, Lathe, Milling, Pumps, Conveyors, Mach3, Fan, Cooling, Compressor, Three-phase motor and other machines!.
  • Spacing 2.54mm bar connector, 5-pin plug. DC cooling fan low noise, large air volume..
  • The machine is screwed to ensure the safety and reliability of the use. Three anti-paint protection lines, improve and extend the life of the fuselage..
  • The operator panel can be moved out and extended by 2M, 1.5M, 1M, 30CM. 1 Year replace or refund!!!.
Check Stock

3-Phase Voltage Monitoring Relay AC 220-440V Phase Sequence Protection Small Size Protection for Industry Applications

  • Dynamic phase loss, static phase loss protection: refers to the phase failure of any phase when the protected device is in the running state or non-operating state. The indicator light is in the form of red light and priority.
  • Wrong phase protection: A protection measure to prevent the phase sequence of L1, L2, L3 three-phase AC power supply from being connected incorrectly. Instant action. The indicator light is in the form of yellow light..
  • Voltage Unbalance Protection: Refers to a voltage imbalance that will affect the safe operation of the device. When the voltage imbalance rate is higher than 8%. The form of the indicator light is: the lack of phase red light is on, and priority..
  • Delay protection: When there is a fault, the monitor will delay after 1~2 seconds, and the relay will release..
  • The protection function of the monitor is not affected by the current of the line or load, the inrush current, the unbalanced current and the nature of the load. Long-term work with full performance and full climate. Power consumption is no more than 2W..
Check Stock

Voltage Monitoring Relay Phase Sequence Protection TG30S Phase Sequence Relay 3-Phase Mini for Industry Applications

  • Dynamic phase loss, static phase loss protection: refers to the phase failure of any phase when the protected device is in the running state or non-operating state. The indicator light is in the form of red light and priority.
  • Wrong phase protection: A protection measure to prevent the phase sequence of L1, L2, L3 three-phase AC power supply from being connected incorrectly. Instant action. The indicator light is in the form of yellow light..
  • Voltage Unbalance Protection: Refers to a voltage imbalance that will affect the safe operation of the device. When the voltage imbalance rate is higher than 8%. The form of the indicator light is: the lack of phase red light is on, and priority..
  • Delay protection: When there is a fault, the monitor will delay after 1~2 seconds, and the relay will release..
  • The protection function of the monitor is not affected by the current of the line or load, the inrush current, the unbalanced current and the nature of the load. Long-term work with full performance and full climate. Power consumption is no more than 2W..
Check Stock

Voltage Monitoring Relay Protection 3-Phase AC 220-440V Small Size Phase Sequence Protection Phase Sequence Relay for Industry Applications

  • Dynamic phase loss, static phase loss protection: refers to the phase failure of any phase when the protected device is in the running state or non-operating state. The indicator light is in the form of red light and priority.
  • Wrong phase protection: A protection measure to prevent the phase sequence of L1, L2, L3 three-phase AC power supply from being connected incorrectly. Instant action. The indicator light is in the form of yellow light..
  • Voltage Unbalance Protection: Refers to a voltage imbalance that will affect the safe operation of the device. When the voltage imbalance rate is higher than 8%. The form of the indicator light is: the lack of phase red light is on, and priority..
  • Delay protection: When there is a fault, the monitor will delay after 1~2 seconds, and the relay will release..
  • The protection function of the monitor is not affected by the current of the line or load, the inrush current, the unbalanced current and the nature of the load. Long-term work with full performance and full climate. Power consumption is no more than 2W..
Check Stock

ATO 3 hp 2.2kW 10A VFD, Single Phase 120V Input, 1phase/3phase 220V Output Variable Frequency Drive Motor Control

  • ATO 3 hp (2.2 kW) VFD, single phase 110v/120v input, single phase or three phase 220v output variable frequency drive, specially designed for 120v power supply.
  • 【voltage&frequency】Input voltage : 1 phase 120V AC ±15%.
  • Output voltage: 1 phase or 3 phase 220V AC ±15%.
  • 【APPLICATION】: ATO 110V VFD Can be widely applied to drive the AC motor, such as fans, pumps, power tools, etc..
  • 【TIPS】: Choose a VFD base on motor rated current: VFD output current ≥ motor rated current.
  • 【CUSTOMER FIRST】: If you have no experience in driving a VFD, be sure to refer to the instructions before operating a VFD.If you are not sure about the size or have any issue about the product or service, please don't hesitate to email us. We will answer you within 12h.
Check Stock