Top Solid State Voltage Stabilizer Reviews

SEVENSTAR AR 5000W Heavy Duty Voltage Reglator/Stabilizer with Built-in Step Up/Down Voltage Transformer

This CE certified 5000-Watt stabilizer/transformer can convert 110/120V to 220/240V or convert 220/240V to 110/120V. Compatible with 50Hz/60Hz.
It can regulate input voltage from AC 75V-130V or 180V-260V to output voltage: AC 110V+-4-percent or AC 220V + - 4-percent. Meter on front shows exact....
This stabilizer can regulate fluctuating voltage into general voltage output. Voltage stabilizer good for countries with unstable voltage supply.
Two universal outlets for 220V accept plugs from most countries. Three 110V outlets for 2 or 3 pin USA plugs. On/off switch. Indicator lamp.
Insulated power cord wired with a European shucko plug. Heavy metal casing. Fuse protected with fuse protected with built in circuit breaker.

Check Stock

Opto 22 DC60MP MP Model DC Control Solid State Relay, 60 VDC, 3 Amps, 4000 VRMS Isolation Voltage

Special attention: the current of this product is 10A for a long time.A large heat sink or fan need to be added.Model: SSR-40DA Solid State Relay 40A DC to AC.
Input voltage: 3-32V DC Output voltage: 24-380V AC.
Item size: 6.2 x 4.5 x 2.3cm/ 2.4 x 1.8 x 0.9inch(L*W*H).

Check Stock

TWTADE 2PCS SSR-25 DA 25A 3-32V DC / 24-380V AC SSR Single Phase Solid State Relay ssr-25da

Special attention: The current of this product is 10A for a long time.A large heat sink or fan need to be added.Model: SSR-25DA Solid State Relay 25A DC to AC.
Input voltage: 3-32V DC Output voltage: 24-380V AC.
Item size: 6.2 x 4.5 x 2.3cm/ 2.4 x 1.8 x 0.9inch(L*W*H).

Check Stock

TWTADE 2PCS SSR-40 DA 40A DC 3-32V to AC 24-380V SSR Single Phase Solid State Relay ssr-40da

Special attention: the current of this product is 10A for a long time.A large heat sink or fan need to be added.Model: SSR-40DA Solid State Relay 40A DC to AC.
Input voltage: 3-32V DC Output voltage: 24-380V AC.
Item size: 6.2 x 4.5 x 2.3cm/ 2.4 x 1.8 x 0.9inch(L*W*H).

Check Stock

uxcell BEM-14840DA 3-32V DC to 24-480V AC 40A Output Single Phase SSR Solid State Relay

Total Size (Approx.) : 58 x 45 x 32mm / 2.3" x 1.8" x 1.26" (L*W*T).

Check Stock

Baomain SSR-60DA 60A Solid State Relay Module 4-32VDC / 24-480VAC + Heat Sink

Photocoupler isolation between input control signal and controlled power, isolation surge voltage up to 7500V..
Input signal turn-on voltage DC 3 to 32V, turn-off voltage DC 0 to 0.8V. LED indication for relay turn-on..
Output voltage range: AC 90 to 250V(50/60Hz). Maximum on-state average current 3 Amp. Maximum on-state current 10 Amp (003c 10 seconds). Non repetitive surge peak on-state current: 120 Amp (003c20mS). Load type: General purpose..
This is a simple and practical solid state relay module, which is very convenient to use, for Arduino, Raspberry Pi, ESP32, PLC or other projects. The GPIO of these controllers are directly connected to this relay input to control the mains power, and it is suitable for most loads less than 350 Watts (for 115VAC)/700 Watts (for 230VAC)..
Compact ABS plastic case and wires connect for easy mount. Two screw mounting holes are convenient for you to fix it on the wall or wooden board. Of course, you can also choose not to lock the screw..

Check Stock

Inkbird SSR Solid State Relay SSR 40DA for PID Thermostat Temperature Controller

Model No.: SSR-80DA；If you want to reach 80A, you need to add a large heat sink and fan.
output Voltage : 24-480vac；Special attention:This relay cannot be used for more than 30A for a long time.If that actual use current exceeds 15A，It is necessary to separately configure the heat sink..
Total size (approximate) : 58 x 45 x 32Mm/2.3" x 1.8" x 1.26" (l*w*t).
material : metal, plastic, electronic parts.

Check Stock

Twidec/Output Single Phase SSR Solid State Relay 80A 3-32V DC to 24-480V AC SSR-80DA

Model No.: SSR-80DA；If you want to reach 80A, you need to add a large heat sink and fan.
output Voltage : 24-480vac；Special attention:This relay cannot be used for more than 30A for a long time.If that actual use current exceeds 15A，It is necessary to separately configure the heat sink..
Total size (approximate) : 58 x 45 x 32Mm/2.3" x 1.8" x 1.26" (l*w*t).
material : metal, plastic, electronic parts.

Check Stock

SparkFun Qwiic Quad Solid State Relay Kit - Attach 4 Solid State relays to a Single PCB - Control Some serious Power All from The Easy-to-use Qwiic Connect System - configurable I2C

This kit allows you to assemble up to four of these solid state relays on a single PCB and control them all via I2C from your favorite microcontroller..
The Quad Solid State Relay Kit comes with four solid state relays rated up to 40A at voltages between 28-380 VAC so you can switch some serious power with this board all from a single Qwiic connector attached to a low-powered microcontroller..
Features: Operating Voltage: 2.5-3.6V (3.3V recommended). I2C Address: 0x08 (Default), 0x09 (Alternate via jumper). Max Current (Through Relay): 40A (24-380VAC). Zero Cross Trigger. Normally Open Circuit Only.
Includes: 1x Qwiic Quad Solid State PCB. 4x Solid State Relay - 40A (3-32V DC Input). 8x 4-40 Hex Nut. 8x 3/8in. Phillips Machine Screw - 4-40 Thread. Hook-up Wire 8" - 22 AWG (Red). Hook-up Wire 8" - 22 AWG (Black).
Assembly required. Tools are not included. You will need a screwdriver and wire clippers/strippers..

Check Stock

uxcell NTC Thermistors Resistor MF52-103/3435 10K Ohm Inrush Current Limiter Temperature Sensor Pack of 40

【Quality】 - Directly Inserted Negative Temperature NTC Thermistors have large material constant, large B value, with small residual resistance.Thermal shock resistance, with wide range of operating temperature..
【Feature】 - The NTC thermistors are reliable and stable, with wide range of over-current control..
【Advantage】 - With small size and large power, NTC thermistors have strong capacity to inhibit surge current..
【Application】 - NTC Thermistor is widely used for controlling the inrush current of motor, heaters, bulb voltage stabilizer, electronic energy-saving lamp, etc..

Check Stock

Wired DC-AC 3Amp Isolated Solid State Relay Module, SSR in 3-32VDC Out 90-250VAC

10DA/25DA/40DA/50DA/50DA-H/60DA/75DA/80DA/100DA/25AA/40AA/50AA/60AA/5AA/80AA/100AA/10VA/25VA/40VA/50VA/60VA/75VA/80VA/100VA.
load voltage: 24~480V/AC，Control voltage 3-32VDC.
SSR -10DA/25DA/ 40DA/50DA/50DA-H DC control AC SSR white shell Single phase Solid state relay WITHOUT plastic cover.
work instruction: LED，In the closed state, special scenarios where the off-state leakage current is less than 5MA are not applicable. Please purchase with caution..

Check Stock

Gimbal Stabilizer for Smartphone with Extendable Selfie Stick and Tripod, 1-Axis Multifunction Remote 360°Automatic Rotation, Auto Balance for iPhone/Android

The most cost-effective stabilizer: a single-axis motor with a high-precision motor that can maintain a horizontal state, super anti-shake, Can take photos as you walk, automatically correct the shaking of your hand to prevent blurry shots, and can produce high-quality video and animation. It can meet the basic needs of most users. Compared with the three-axis price, it saves 2/3 and is the most cost-effective mobile phone stabilizer..
Anti-shake selfie stick with stable function: Built-in single-axis motor, 360-degree remote control and automatic rotation, Can always maintain the horizontal state, Solve the problem of hand shaking during filming, no longer have to worry about the photo blur, output high-quality video. the detachable remote make it possible to take all-in family photos for memorable events, also works great for video conference/interview, Travel, make little videos,Vlog,Youtube,Tiktok, live streaming, etc..
Mobile phone tripod: Open the handheld part of the stabilizer and place it on the desktop to become a mobile phone tripod.Adjust the height of the four-section aluminum alloy rod to choose the right position for you. Watch the video, shoot the video,Featured with beauty retouching, enlarge your charm in the video..

Check Stock

Gimbal Stabilizer for Smartphone with Extendable Selfie Stick and Tripod, 1-Axis Multifunction Remote 360°Automatic Rotation, Auto Balance for iPhone/Android Black

The most cost-effective stabilizer: a single-axis motor with a high-precision motor that can maintain a horizontal state, super anti-shake, Can take photos as you walk, automatically correct the shaking of your hand to prevent blurry shots, and can produce high-quality video and animation. It can meet the basic needs of most users. Compared with the three-axis price, it saves 2/3 and is the most cost-effective mobile phone stabilizer..
Anti-shake selfie stick with stable function: Built-in single-axis motor, 360-degree remote control and automatic rotation, Can always maintain the horizontal state, Solve the problem of hand shaking during filming, no longer have to worry about the photo blur, output high-quality video. the detachable remote make it possible to take all-in family photos for memorable events, also works great for video conference/interview, Travel, make little videos,Vlog,Youtube,Tiktok, live streaming, etc..
Mobile phone tripod: Open the handheld part of the stabilizer and place it on the desktop to become a mobile phone tripod.Adjust the height of the four-section aluminum alloy rod to choose the right position for you. Watch the video, shoot the video,Featured with beauty retouching, enlarge your charm in the video..

Check Stock