Fluke BT510 Battery Analyzer
- ... the car battery and the black clip to the negative electrode of the car battery, press button to “Positive”side with LED lighting RED, conact the tip to positive terminal of tested component to active the component. If LED turns to GREEN with buzzer, stop testing and check the component if defective or not, or rating current of component is higher than that of this tester..
- [ Packing Include ]: 1 X Power Scan, 1 x Probe Tip, 1 x Battery Hookup Clips, 1 x User Manual, 2 x clips. The cable length of the circuit tester is about 4m(13ft) which allows you access and test any electrical system easily. Note: This circuit tester can not be used for 110/220V systems, it is only used for DC 6-24V systems. Do not use on AC voltage..
- [ NOTE ]: Before performing the test, please make sure that your tester is properly connected. Connect the red clip to the positive terminal of the car battery. Then connect the black clip to the negative terminal of the car battery. During the continuity test, the auxiliary ground wire needs to be connected to one side of the wire under test. When testing components in/out of the vehicle's electrical system, connect the auxiliary ground wire to the negative pole of the component under test..