Top Motor Starting Reviews

CNCEST Outboard Boat Motor Engine Inflatable Boat Fishing Boat Engine Power for Sailboats Small Yachts

  • ...le for both saltwater and freshwater..
  • Full throttle perating range: 4000-5000r/min.
  • Recommended fuel: Regular unleaded gasoline.
  • 【Warm Note】- Please add gear oil to the gears before use the motor and replace gear oil after the run-in period(10 hours). Our outboard motor doesn't with gear oil, please prepare it by yourself.
  • 2 strokes 3.5 hp and 3.6 hp are controlled by the handle, which is operated by the clutch. There is no Neutral, only idle mode or low speed mode..
  • 【Hard To Start?】- If the outboard motor is hard to start, please do as follows: 1.Please make sure the ratio of Gasoline: Oil = 35:1., please do use special oil for 2-stroke motor.
  • 2.Press the button on the carburetor for several times until the yellow and black pipes are full of oil.
  • 3.Leave the throttle in the start position before starting,and then keep it in the ON pos....
Check Stock

VEVOR Air Compressor Electric Motor, 5 HP SPL 3450 RPM, 208-230 Volt 3.1 KW Single Phase, 56 Frame 5/8" Keyed Shaft 60 Hz, Commercial-Duty CCW Rotation, 1.88" Shaft Length NEMA for Air Compressors

  • ...overheating. The attached steel bracket also offers excellent stability. Two capacitors and high-quality ball bearings ensure long service life..
  • Overload Thermal Protector: The heavy-duty electric motor adopts a manual reset knob against high-temperature overload. Reduced starting amperage design ensures the reduced voltage starting at a rated load. Insulation class-F, ENC-IP23, Ambient temperature-104℉ / 40℃, Duty-CONT, Pole-2..
  • Heat Dissipation Holes: The air compressor motor has multiple heat dissipation strips for heat dissipation. It can also guard chips and objects against dropping in the motor and causing accidents..
  • Designed for Air Compressors: The open drip-proof motor is better used in a relatively clean and dry environment. Specifically designed for air compressor duty uses. Please purchase a motor according to the specific needs of your compressors..
Check Stock

Bussmann BP/TL-15 15 Amp Time Delay, Loaded Link Edison Base Plug Fuse, 125V UL Listed Carded, 3-Pack

  • Will withstand typical motor starting surges.
  • Use in residential or light-duty circuits that contain electric motors.
  • These fuses thread into fuse receptacles.
Check Stock

HQRP 70uF 220V Start Capacitor Compatible with Genie 000954419988A 000954419988A.S 19988A 19988A.S Garage Door Opener 1/2HP Models 70MFD CD60 UL Listed

  • Genie 18004B, 18004-B Garage Door Opener Motor Starting Capacitor..
  • Compatible with ALL Genie 1/3 Horse Power Garage Door Openers except models GPS-700 Stealth, PMX-700 Openers and Excelerator model Garage Door....
  • 50-60 Microfarad (MFD), 220 Volts AC (VAC), 60 Hertz (Hz).
  • Genie 18004B Garage Door Opener Motor Starting Capacitor. Compatible with ALL Genie 1/3 Horse Power Garage Door Openers except models GPS-700 Stealth,....
Check Stock

Little Giant 506160 6-CIA-ML 1/3 HP 2760 GPH 115-Volt Low Level Sump Pump, Blue

  • AUTOMATIC SUBMERSIBLE SUMP PUMP: designed for compact sump systems with integral diaphragm switch activates when water reaches 4 to 7 inches and shuts off when water drops down between 1.5 and 3.5 inches.
  • BUILT TO LAST: Epoxy-coated cast iron housing.
  • nitrile/carbon/ceramic mechanical shaft seal.
  • CONTINUOUS DUTY MOTOR: 1/3 HP shaded pole motor, 9.0 running Amps, 14.3 starting Amps, 720 Watts, thermally protected, CSA listed in the USA and Canada.
  • APPLICATIONS: designed for compact sump pump systems and general water transfer application. Must sit in water to activate the switch..
Check Stock

Dental 1000rpm 20:1 Speed Reducing Attachment

  • The blades are synthetic injection molded with high strength plastic, 30% carbon fiber components , and anti‑ultraviolet and anti‑corrosion materials..
  • The wind wheel runs smoothly, reliably and quietly..
  • The motor adopts unique magnetic circuit design, and its starting torsion is very small, which can effectively guarantee the starting ability of breeze..
  • Wind has light weight, small size, and shape is better than similar products..
  • The design of wind blade accords with the aerodynamic principle..
Check Stock

HANGKAI Outboard Motor,12HP 2 Stroke Outboard Motor Boat Engine Heavy Duty Fishing Boat Engine Water Cooling Sys 93 Gasoline 169CC 8.8KW Tilt shaft

  • 【Main Parameters】Displacement: 169CC.
  • 【Prefect Desigh】Light Weight,Easy To Carry,Unique Appearance,Large Tank Capacity.Environmental Protection:Clean and Pure Gasoline Fuel Makes Emissions Targets The Outboard Engine Has Been Able To Meet The CE Certification,Which Contributed To The Promotion Of Green Sports..
  • 【Note】Several issues with this motor first the linkage that goes from the gear selector to the starting rope to block the rope to be pull when the motor is in gear was unattached , and still after fixing it every time you go into any gear it gets unattached second, the starting rope doesn't retract all the way when you attend to start the engine..
  • 【Noise Smaller】The Machine Can Run In The Maximum Throttle Continuous Operation,Power Attenuation,With Circulating Oil Lubrication System and Direct Bearing Supporting Precision,Smooth Operation and Quiet,Sound Design,Excellent Noise Smaller,More Comfortable To Use..
  • 【About certification】We can only provide CE certification, there is no other certific....
Check Stock

IMAYCC 80cc Bicycle Engine Kit, 2-Stroke Motorized Bicycle Kit Fit for 26-28' Bikes, Bicycle Motor Engine Kit with Wired Digital Computer (Silver)

  • ...inder gasoline engine, wired digital computer, the engine power/speed is 2.1Kw/5000rpm, so you can enjoy a faster riding speed, the upgraded bicycle has better durability and supports long-distance riding, make it easier to use outdoors..
  • 【80cc Bike Motor Kit】Engine type: single-cylinder, air-cooled, two-stroke. Starting method: foot pedal starting. Ignition method: CDI ignition. Number of sprocket teeth: 44 teeth. Number of chain teeth: 110 knots. Spokes: 36..
  • 【Bicycle Motor Compatibility】IMAYCC bike engines are suitable for most 26-28″ wheeled bikes (mountain bikes, cruisers, motorcycles, road bikes) with V-frames. There should be 10″ and more clearance between the bottom bracket and top bar of the frame..
  • 【2.5L Black Teardrop Fuel Tank】Fuel type: 90#, Mixing Ratio of Fuel and engine Oil: 16:1 for new equipment, 20: 1 the run-in period (after running 500km). Driving on a smooth road at a speed of 20-25Km/h, fuel consumption of 2-2.5L per 100Km..
  • 【Notes】The rider needs basic hardware skills, tools, and around 2-3 hours for installation and fine tuning adjustments. If you do not have experience or the first time on installing the motor kit, before installing, please kindly read our instruction and search “80cc bicycle engine kit” ....
Check Stock

Hamilton Beach HMD400 120V Triple Spindle Commercial Drink Mixer

  • Cup Activated: Operators can start and stop mixing action by inserting the cup into the cup guide or by using the pulse switch on the top of the mixer..
  • Hands-free Operation: Provided by two level cup rest. Holding cup in upper position of cup rest activates motor. Lower position holds cup in place without starting motor..
  • 3-Speed Universal Motors: Built to last with permanently sealed ball bearings. Each motor is individually balanced to minimize vibration. Operator can easily replace motor in minutes..
  • Easy to Clean: Smooth housing made of stainless steel and heavy-duty die-cast aluminum wipes clean easily. The cup guide also removes for dishwasher safe cleaning..
  • Sealed Rear Housing: The airflow design within the mixer does not require venting, which eliminates risk of water ingress and motor failure..
Check Stock

3D Dental HP-PB Hyrdolux Push Button Hand Piece

  • Wind has light weight, small size, and shape is better than similar products..
  • The wind wheel runs smoothly, reliably and quietly..
  • The motor adopts unique magnetic circuit design, and its starting torsion is very small, which can effectively guarantee the starting ability of breeze..
  • The design of wind blade accords with the aerodynamic principle..
  • The blades are synthetic injection molded with high strength plastic, 30% carbon fiber components , and anti‑ultraviolet and anti‑corrosion materials..
Check Stock

Little Giant 6-CIA 115 Volt 1/3 HP 2760 GPH Cast Iron Submersible Sump Pump with Integral Diaphragm Switch 10-Ft Cord Blue 506158

  • Automatic Submersible Sump Pump: with integral diaphragm switch activates when Water reaches 7 to 10 inches and shuts off when Water drops down between 1 and 4 inches.
  • Built To Last: Epoxy-coated cast iron housing.
  • nitrile/carbon/ceramic mechanical shaft seal.
  • Continuous Duty Motor: 1/3 HP shaded pole Motor, 9.0 running Amps, 14.3 starting Amps, 720 Watts, thermally protected, CSA listed in the USA and Canada.
  • Applications: designed for sump Pump systems and general Water transfer application.
  • must sit in Water to activate the switch.
Check Stock

Little Giant 9S-SMPXRT-K 4/10 HP, 115-Volt, 6000 GPH Pre-Packaged Simplex Sewage Basin/Pump System - Assembly Required, Black/Blue, 509074

  • AUTOMATIC SUBMERSIBLE SUMP PUMP: with integral diaphragm switch activates when water reaches 7 to 10 inches and shuts off when water drops down between 1 and 4 inches.
  • BUILT TO LAST: Epoxy-coated cast iron housing.
  • nitrile/carbon/ceramic mechanical shaft seal.
  • CONTINUOUS DUTY MOTOR: 1/3 HP shaded pole motor, 9.0 running Amps, 14.3 starting Amps, 720 Watts, thermally protected, CSA listed in the USA and Canada.
  • APPLICATIONS: designed for sump pump systems and general water transfer application.
  • must sit in water to activate the switch.
Check Stock

Little Giant 6-CIA 115 Volt 1/3 HP 2760 GPH Cast Iron Automatic Submersible Sump Pump with Integral Diaphragm Switch 10-Ft Cord Blue 506158

  • AUTOMATIC SUBMERSIBLE SUMP PUMP: with integral diaphragm switch activates when water reaches 7 to 10 inches and shuts off when water drops down between 1 and 4 inches.
  • BUILT TO LAST: Epoxy-coated cast iron housing.
  • nitrile/carbon/ceramic mechanical shaft seal.
  • CONTINUOUS DUTY MOTOR: 1/3 HP shaded pole motor, 9.0 running Amps, 14.3 starting Amps, 720 Watts, thermally protected, CSA listed in the USA and Canada.
  • APPLICATIONS: designed for sump pump systems and general water transfer application.
  • must sit in water to activate the switch.
Check Stock