Top Motor Potentiometer Reviews

Acxico 1Pcs DC12V 30A High-Power Brushless Motor Speed Controller DC 3-Phase Regulator PWM Controller Driver

  • With micro single-chip system, this speed control can achieve simple system programming, which can suit better high-speed high-power brushless motors..
  • Safety Startup: To avoid any injury, the motor will not start up immediately if the potentiometer of speed controller is not at the lowest gear, which is necessary for high-speed high-power motor to protect user's safety..
  • Temperature Protection: The speed control has aluminum heat sink, which allows it work at 30 A continuously. When temperature reaches 110 celsius degree, temperature detect system will send a protection signal and system will auto decrease 60% power output to protect speed control and motor. It will back to normal power after temperature is decreased. To protect the actuator module, please dissipate heat during long-time using..
  • The signal loss prevention: Auto shut down when there is no signal detected from PWM signal generator(potentiometer )..
  • Power Identification System: The speed control has power identification system, which is designed for high-speed high-power motors such as in model plane. It is not suitable for low-power brushless motors..
Check Stock

ICQUANZX DC Brush Motor Speed Controller DC10-55V Forward Reverse with Digital Display&Fan Inside 40A-60A

  • Input supply voltage: DC 10V-55V;Maximum current: 60A; Continuous current: 40A.
  • speed regulation mode: potentiometer (linear);Speed range: 0-100%.
  • Potentiometer with switch function,High power speed controller switch which is much more adaptable..
  • The input voltage must be equal to the rated voltage of the motor within the range of DC10-55V.
Check Stock

MEGA 2560 Starter Kit Ultra (100% Arduino IDE Compatible) w/ Battery Holder, Sensors, Modules, Resistor kit and Components (no Supply)

  • -10 * LEDs 5mm Diffused RED -10 * LEDs 5mm Diffused GREEN -10 * LEDs 5mm Diffused YELLOW -5 * LEDs 5mm Ultrabright WHITE diffused -3 * LEDs 5mm Red / Green / Blue Diffused RGB -Shift Register (Series to Parallel IC) 74HC595 - NPN Transistor BC547 - PNP Transistor BC557 - Adjustable Knob Resistor 1kOhm (Potentiometer) - Adjustable Knob Resistor 10kOhm (Potentiometer).
  • - Resistor Pack 1/4W 1% accuracy, with 10pz of each value: 100, 220, 330, 470, 1K, 2K2, 4k7, 10K, 22K, 47K, 100K, 220K, 1M - 40-pin header 2.54 mm -40-pin header at right angle 2.54mm -5 * Capacitors for bypass tantalum 0.1uF -5 * Jumpers for header.
Check Stock

PWM DC Motor Speed Controller, Stepless Speed Control Switch Controller 30A DC6-60V 12V 24V 36V 48V

  • 【convenient screw terminals】 This motor speed controller uses screw terminals for convenient and quick wiring. Support motor: DC brush motor..
  • 【momentary start/stop switch】 Momentary start/stop switch and a speed control potentiometer..
  • 【digital display】 Motor regulator 12v designed with a digital display that shows the rate in percentage of actual speed to maximum speed..
  • 【stable】 This simple and easy-to-use DC motor speed controller has an stable performance. The PWM DC motor controller has a continuous current of 20A..
  • 【high quality circuit board】 Speed controller is made with high quality circuit board which ensures a longer service life..
Check Stock

Laing E10-NSHNDNN2W-08 Spa Circulation Pump Black

  • High density ceramic bearing ball and graphite impeller bearing cap designed for high efficiency and long life..
  • Highly efficient and ultra quiet spherical motor design. Pump is designed for continuous operation. All ratings are within working limits of the motor.
  • Unique patented design has no mechanical seal which is a potential leak path..
  • Embedded microprocessor control is self-regulating and available with variable speed dial control (potentiometer) on the pump or as an optional PWM....
  • Built in DRY RUN protection is programmed into the software to help eliminate motor and pump damage if the pump is ran w.
Check Stock

Laing E10-NSHNDNN2W-02 Spa Circulation Pump

  • High density ceramic bearing ball and graphite impeller bearing cap designed for high efficiency and long life. E10-NSHNDNN2W-02 only supports 230VAC..
  • Highly efficient and ultra quiet spherical motor design. Pump is designed for continuous operation. All ratings are within working limits of the motor.
  • Unique patented design has no mechanical seal which is a potential leak path..
  • Embedded microprocessor control is self-regulating and available with variable speed dial control (potentiometer) on the pump or as an optional PWM....
  • Built in DRY RUN protection is programmed into the software to help eliminate motor and pump damage if the pump is ran w.
Check Stock

RioRand PWM DC Motor Speed Controller Switch Control 7-70V 30A Fuse

  • Wide voltage input 7-70V, maximum output current 30A .Adjustable potentiometer soft cable(about 15CM) can be separated, with running stop brake function.
  • Can be use on long hours of work: Circuit optimization design, stable Adjust the motor smooth no noise no vibration, with power indication, wide duty cycle adjustment range.
  • Using imported high-voltage MOS tube, three pressure 100V high-frequency low-resistance capacitors, automotive fuses.
  • Adjust the motor smooth no noise no vibration, with power indication, wide duty cycle adjustment range.
  • PWM Frequency and Share Space: 12KHZ ,The knob has a switch function, which can control the motor speed from 0% to 100%..
Check Stock

Speed Controller AC 50-220V 2000W 25A Motor Controller SCR High-power Electronic Voltage Regulator Module Motor LED Dimmers (1PCS)

  • The output voltage is adjusted anywhere between 50V-220V for use with electrical appliances.
  • It can use to such as electric stove, water heater tune thermal, lighting dimmer, small motor speed, electric iron thermostat, and achieve dimming, thermostats, pressure regulator effect..
  • The motor speed controller can easily provide a continuous current to your DC motor or other DC load..
  • Universal DC Motor Speed Controller.Control the speed of a DC motor with this controller..
  • Before you attempting to wire the controller, make sure all power is disconnected. Cut any one of the battle line or zero line of the lamp or electrical appliances, and connect wires refer to the "wiring diagram".
  • Turn on the power, and adjust the potentiometer..
Check Stock

OCR 1K-500K ohm Potentiometer Kit 35 Sets Knurled Shaft Linear Potentiometer with Knobs Nuts and Washers 7 Values 1K 5K 10K 20K 50K 100K 500K 3 Terminal Rotary Potentiometer

  • ✅ Top adjustment type and knurled shaft single linear 3 terminal 7 values 1K 5K 10K 20K 50K 100K 500K Ohm rotary potentiometer..
  • ✅ Linear knurled shaft potentiometer. Shaft diameter:6mm, shaft length:17mm.
  • Mounting thread diameter:6mm, base size:16*7mm.
  • ✅ Potentiometer kit offers 35pcs potentiometer knob caps. 300 degree rotary knob for easily control the potentiometer..
  • ✅ Top adjustment type and knurled shaft for easy operate in daily use time. Stander round shaft can be push on potentiometer easily..
  • ✅ Taper potentiometer used for volume control of audio sets, car radios, amplifiers, mixers, synthesizers and other appliances. For electronic....
Check Stock

Onyehn DC Motor PWM Speed Controller3V 6V 12V 24V 35V Speed Control Switch Mini LED Dimmer 5A 90W(Pack of 2pcs)

  • Mini Style DC Motor Speed Regulator controls the speed of a DC motor by adjusting Pulse-Width-Modulated (PWM)..
  • Mini DC 6-35V 5A PWM Motor Speed Controller. Wide voltage DC motor speed controller, PWM duty cycle: 1% -100%..
  • Default disconnection of short circuit point, suitable for 5-35V input. Manually connect the short circuit point according your needs, suitable for low power 3-15v input..
  • By screwing the potentiometer, you can turn off power supply output. High voltage and high current resettable fuse, overcurrent automatic disconnection, power off for cooling for a few seconds fuses automatic recovery..
  • It is not only to use for dc motor controls of the speed,but also to use for adjust the LED light..
Check Stock

7-80V PWM DC Motor Speed Controller Switch 30A,Motor Speed Control Regulator

  • 1️⃣ 7-80V PWM DC Motor Speed Controller Switch 30A,Motor Speed Control Regulator.
  • 2️⃣ Wide voltage 7-80V high current 30A Design Wide range of applications, on-board switch with operation Stop brake function, adjustable potentiometer soft cable can be separated Line length 30CM..
  • 3️⃣Circuit optimization design Wide range of duty cycle adjustment, smooth motor without vibration, no vibration, with power indication, stable circuit design for long working hours..
  • 4️⃣Adopt imported high-voltage MOS tube, three high-voltage 100V high-frequency resistance capacitors, and fuses for braking. The parameters are not easy to heat and easy to replace. The standard aluminum housing protects the internal circuits and components for long-term durability..
  • 5️⃣Package Contents:1 x 7-80V PWM DC Motor Speed Controller Switch 30A.
  • Amazon satisfied customer service & fast ship..
Check Stock

AmpFlow E30-150 Brushed Electric Motor, 12V, 24V or 36 VDC, 5600 RPM

  • ...formation, ensuring it will not rust easily. This dc electric motor is a forward and backward rotation motor so that you can switch rotation gears effortlessly..
  • Speed Controller Included: This dc electric motor brushless comes with a controller to provide speed control at a desirable range, speed adjustment method: Potentiometer. Model: BY15WF01-A, Current: 33A, Phase Degree: 120°, Conversion Efficiency: 90%, Under Voltage Protection Voltage: 41±0.5V..
  • Multiple Application: The brushless motor outshines the brushed motor due to its high efficiency, power conservation, low noise, long lifespan, and stable operation. It is suitable for go karts, scooters, e-bikes, ATVs, motorized bicycles, mopeds, mini bikes, pocket bikes, etc. Get up to speed with a brushless motor..
Check Stock

KeeYees 7-70V 30A PWM DC Motor Speed Controller Switch Control 12V 24V 36V 48V with 30 Amp Fuse

  • 【Wide Voltage】: Wide voltage input 7-70V, maximum output current 30A (Please refer to the recommended power range for actual use current. It is recommended that 12V within 250W, 24V within 350W, 48V within 450W, and 60V within 500W. ).
  • 【Speed Control Knob】: The knob has a switch function, which can control the motor speed from 0% to 100%. Adjustable potentiometer flexible cable can be separated, the cable length is 15CM..
  • 【30A Fuse】: This set contains a 30A fuse to prevent shorting of the motor interface. Double protection of your Motor and Motor Speed Controller..
  • 【Note 1】: The power of the input power supply must be greater than 1.5 times the rated power of the motor to make the motor work (note: the input voltage and the rated voltage of the motor must be consistent)..
  • 【Note 2】: If there is a forward-reverse circuit regulator on the children's car, please be sure to connect the speed controller between the power supply and the forward -reverse circuit regulator of the children's car. Otherwise, the speed controller may be damaged..
Check Stock