TRIGORILLA ANYCUBIC RAMPS 1.4 Control Board Panel Motherboard Shield for Arduino Reprap Prusa Mendel
- ❀ Fully assembled & tested, no soldering required.
- ❀ Designed to fit the entire electronics needed for a RepRap in one small package for low cost.
- ❀ Using a dedicated power supply chip, support 12V-24V power input, the voltage converter chip Ramps solve the heating problem.
- ❀ Accept 24V input, the same system power can heat the bed current is reduced to 1/4, an effective solution to the hot bed MOS pipe heat problems.
- ❀ The firmware can use open source firmware Marlin, ramps1.4 identical configuration and can directly replace Ramps1.4.