Honeywell SV9641M4510 Upgraded Replacement for Furnace Smart Gas Valve
These controls communicate directly with an electronic fan timer (ST9160 Electronic Fan Timer for single stage applications.
ST9162 Electronic Fan Timer for two-stage applications) in typical forced warm air furnace applications.
It can directly interface with the appropriate power supplies and a system thermostat for additional appliance applications.
When controlled directly by a thermostat, these controls do not provide a post purge function, because power to the control is removed when the thermostat call for heat ends.
The Systems are suitable for a wide range of fan-assisted combustion gas-fired appliances including furnaces, rooftop furnaces, boilers, unit heaters, infrared heaters, water heaters and commercial cooking appliances.
ZFLXH Space Heater Replacement Parts PP236 Photocell For Reddy Remington Master Knipco Heaters M16656-24
⭐PP236: Photocell Assembly should be used with 104068-02 ignition control boards on oil fired heaters..
⭐This photocell is used with heaters that have the hot surface ignitor (glow plug). UNLESS you have the DESA upper tier heaters that have the plastic handle and shroud that covers the fuel tank. That photocell is part# M16656-21.
This photocell is used with heaters that have the hot surface ignitor (glow plug). UNLESS you have the DESA upper tier heaters that have the plastic handle and shroud that covers the fuel tank. That photocell is part# M16656-21.
A brand-new, unused, unopened, undamaged item in its original packaging (where packaging is applicable)..
American standard point-of-use electric water heaters are all certified at 300 psi test pressure and 150 psi working pressure. All tanks are also 100% hydrostatically tested at the factory.
American standard point-of-use electric water heaters are all certified at 300 psi test pressure and 150 psi working pressure. All tanks are also 100% hydrostatically tested at the factory.
American standard point-of-use electric water heaters are all certified at 300 psi test pressure and 150 psi working pressure. All tanks are also 100% hydrostatically tested at the factory.