...ace Gages is the most reliable way to test rifle chamber length. Headspace in a rimless cartridge is the distance between the bolt face and a datum line, determined by SAAMI, where the front of the cartridge rests on its shoulder when the bolt is closed..
NO-GO: Corresponds to the maximum headspace we recommend for gunsmiths’ chambering new bolt-action rifles. This is not a SAAMI-maximum measurement. If a rifle closes on a NO-GO gage, it may still be within SAAMI specifications, or it may have excessive headspace. To determine if there is excessive headspace, the chamber should then be checked with a FIELD gage. The NO-GO gage is a valuable tool for gunsmiths’ reaming new chambers, in order to ensure tight and accurate headspace.
GO: Corresponds to the minimum chamber dimensions. If a rifle closes on a GO gage, the chamber will accept ammunition that is made to SAAMI maximum specifications. The GO gage is essential for checking a newly-reamed chamber in order to ensure a tight, accurate, and safe chamber that will accept SAAMI maximum ammo..
PRECISION MACHINED: Manufactured from top-quality, hardened steel and precision ground to ANSI and SAAMI tolerances. Headspace tolerance ground to a very exacting ±.00015. Each Headspace Gage thoroughly in....
Hornady B14 Lock-N-Load Comparator Body with Set of 14 Inserts
Hornady Comparator Kit – The Hornady Lock-N-Load Bullet Comparator is perfect for the reloader looking to measure seating depth of loaded ammunition....
Why Do You Need a Hornady Bullet Comparator – Measuring cartridge lengths across the bullet tips is not a reliable (or repeatable) method for....
Reliable Rounds – Our Bullet Comparator measures rounds from the ogive to provide consistent, precise measurements. You can also use it to check....
Easy Measuring – Our Bullet Comparator easily attaches to the blade of your caliper and uses interchangeable inserts (available in sizes from .17....
Kit Includes – Comparator body and 14 inserts for use with the following diameter bullets: 172, 204, 224, 243, 257, 264, 277, 284, 308, 338, 358,....
Genuine Honda sealed beam 6V headlight for several small Honda 100-175cc models from the 70's. This high quality part is ready to plug into the stock....
Outer Diameter: Approximately 5.3" (135mm) - Connectors: Dual White Female Bullet / Green Male Bullet / Blue Dual Female Bullet - 6 Volt - 35/25W.
Made in Japan by Stanley - HM-9M-S / FC11H - DOT Approved.
Honda part number: 33120-243-672. Note: Check the photo against your current headlight to make sure the brackets are in the same position. It is not....