Top Alternator Wire Connector Reviews

Michigan Motorsports Alternator Wire Harness Plug Fitment For Hitachi Alternators Connector Fits- Nissan Mazda, Ford, Subaru, Mitsubishi, Mercury, Chrysler, Dodge & Plymouth

Alternator Repair Connector Harness 2 PIN Pigtail Fitment for Mitsubishi Hitachi Alternators.
Alternator Wire Harness Plug Fitment for Hitachi Alternators Connector Fits- Nissan Mazda, Ford, Subaru, Mitsubishi, Mercury, Chrysler, Dodge & Plymouth.
Replacement for GY01-18-W9XA L813-18-300 LF18-18-300 Gy01-18-300, GY01-18-300E, GY01-18-300H, GY01-18-300J, Gy01-18-300, 2104174, 13883N.

Assembled with OEM tooling, OEM (connector, lock, seals, and terminals),(uses OEM harness wire colors) for a perfect fit.
Assembled in Wichita, Kansas with USA made OEM grade TXL wire.
4 Pin Alternator Wire Pigtails (For Gen III LS Series Engines).
Wire Pigtail Includes 6 Inches Of Factory Color Wire.
Highest Quality Wire Connectors On The Market, For the Most Dependable, Longest Lasting Connections.

This harness is a 3 wire MAF and a 1 wire alternator. For drive by cable throttle body Only..
Compatible with LS1 4L60E 2003-2007 Chevrolet, GMC, Cadillac and Hummer engine.
suitable for 03-07 all using 4L60E(Vortec engine 4.8 5.3 6.0) gearbox automotive..
All wiring harnesses come with the required instrument panel connections, including speedometer, tachometer, neutral, TCC, fault indicator and DLC port. Red/blue PCM connector and EV1 fuel injector connector..
The 1200-degree glass fiber braid and connector position lock on all circuits are heated before leaving the factory to improve the performance and efficiency of the engine..
The length of the 60-AMP relay harness has been increased by 36 inches, which is convenient for computer installation and easy installation, and there is a complete installation manual..

▲Delco alternator 10Si and 12Si alternator excit wire plug with diode.
▲Ready to plug into '73 & up GM internally regulated alternator.
▲Special diode prevents engine run and voltage feedback.
▲QUALITY ASSURANCE - Made of high quality material ,our wire plugis durable and can be used for a long time..

300 Watts x 1 @ 4-Ohms, 500 Watts x 1 @ 2-Ohms, Frequency 20Hz to 250Hz +/-1dB.
Onboard 12dB/octave LP/HP/AP crossover & Infrasonic filter. Power Wire Gauge- 4 AWG. Power Input Connector-Screw Terminal. Suggested Alternator-75 A.
On-board Punch EQ with +18dB boost at 45Hz. Input Sensitivity: 150 mV to 4 V.
Cast Aluminum Heatsink with Stealth top mounted control panel.
Includes wired remote (Punch Level Control). High efficiency amplifier design that reduces current consumption from the charging system.

Upgrade for your factory battery ground wire, alternator ground wire and alternator power wire.
Premium true-spec OFC wire gives improved sound quality and runs with maximum efficiency.
Flexible insulation wire prevents electrocution, corrosion and damage to components within your car.
Durable and shielded wire that can tolerate heat, vibration and other rough conditions.

Assembled with OEM tooling, OEM (connector, lock, seals, and terminals),(uses OEM harness wire colors) for a perfect fit.
Assembled in Wichita, Kansas with USA made OEM grade TXL wire.
2 Pin Alternator Wire Pigtails (For Gen IV LS Series Engines).
Wire Pigtail Includes 6 Inches Of Factory Color Wire.
Highest Quality Wire Connectors On The Market, For the Most Dependable, Longest Lasting Connections.

(RED/BLUE PCM CONNECTOR & EV1, FUEL INJECTOR CONNECTORS, email us if multec/delphi or ev6 needed) (4L60E)(DRIVE BY CABLE).
NOTE: CHECK WITH US IF YOU ARE UNSURE ABOUT FITMENT. These are after market harnesses and ready to ship (WE CAN SOLVE 99% OF ANY PROBLEMS. SO PLEASE....
All Harnesses are long enough for the PCM to be mounted under the dash (ADDED 36" FOR EASY COMPUTER MOUNTING).
3 wire MAF and a 1 wire alternator. Has the adapter 4L80E harness that you will have to pin 2 wires into the blue pcm. Comes with ENGLISH MANUAL..
There are times when customers may need fuel injector adapters. We offer these adapters, If you request them, during or after the order. Please....

New Aftermarket Part (Not Rebuilt/Refurbished/Repurposed).
Specs: Alternator, Voltage: 12, Amps: 15, Notes: Permanent Magnet, Closed Back.
Specs: Regulator, Electronic & Rectifier, Voltage: 12, Polarity: Negative, Includes Brush Holder?: No, Adjustable?: No, Includes Rectifier?: Yes, Includes Tolerance Ring?: No, Notes: (3) Blue Wires: Stator, (2) Red Wires: B+, (2) Black Wires: B-, (1) Yellow Wire: Ignition, (1) Green Wire: Light.
Replaces OEM Part Numbers: Alternator- John Deere: MIA10312, SE501843, MIA10338, SE501822, AM877557, AM879144, CH15587.
Replaces OEM Part Numbers: Regulator- John Deere: MIA881692, AM877958.

Replaces your vehicle's battery ground-to-chassis wire, the chassis-to-engine block wire, and the alternator charge output wire.
Ring terminals are already crimped to the wires.
Kit Contents: 1qty - 6ft 0AWG XP FLEX RD Cable, 2qty - 4ft 0AWG XP FLEX BK Ground Cable, 8qty - XS Power Brand Heat Shrink.
Kit contents: 8qty - 0AWG Crimp Terminals, 10qty - Wire Clamps, 10qty - Zip Ties, 10qty - Screws.

Direct replacement - this alternator connector matches the appearance and function of the factory hardware on specified applications.
Ideal solution - this connector is a reliable replacement for an original part that is missing or has failed due to fatigue.
Durable construction - this part is made from quality materials to ensure reliable performance and long service life.
Trustworthy quality - backed by team of product experts in the United States and more than a century of automotive experience.
Ensure fit - to make sure this part fits your exact vehicle, input your make, model and trim level into the garage tool.